Crown XLS 1500 525W @ 4 Ohms 2-Channel Power Amplifier

Features:

• XLS High Performance, Lightweight Class D amp weighs less than 11 lbs.
• Integrated PureBand™ Crossover System for better performance and control
• Peakx™ Limiters provide maximum output while protecting your speakers
• XLR, 1/4", RCA inputs provide outstanding flexibility
• Efficient forced-air fans prevent excessive thermal buildup
• Electronically balanced XLR inputs; touch  proof binding post and Speakon® outputs
• Precision detented level controls, power switch, power LED, and six LEDs which indicate signal, clip and fault for each channel
• Three-Year, No-Fault, Fully Transferable Warranty completely protects your investment and guarantees its specifications

Power

• Stereo, 2 ohms (per ch.): 775W
• Stereo, 4 ohms (per ch.): 525W
• Stereo, 8 ohms (per ch.): 300W
• Bridge-Mono, 8 ohms: 1050W
• Bridge-Mono, 4 ohms: 1550W

Specifications:

• Total Harmonic Distortion (THD): < 0.5%
• Intermodulation Distortion (IMD): (60Hz and 7kHz at 4:1)
  From fullrated output to -30dB: <0.3%
• Damping Factor (8 ohm): 10 Hz to 400 Hz: > 200
• Crosstalk (below rated 8 Ohms power):
  • At 1kHz: > 85dB
  • At 20kHz: >55dB
• Input Impedance (nominal): 20 kOhm balanced, 10 kOhm unbalanced
• Load Impedance:
  2 to 8 ohms per channel in Stereo
  4 to 8 ohms in Bridge Mono
• AC Line Voltage and Frequency Configurations Available (± 10%):
  • 120 VAC: 60 Hz
  • 100 VAC: 50/60 Hz
  • 220 and 240 VAC: 50 Hz
• Ventilation: Flow-through ventilation from front to back
• Cooling: Inteal heat sinks with forced-air cooling for rapid, uniform heat dissipation
• Air Volume Requirements (per minute per unit): 80.15 ft³ (2.27 m³)
• Integrated Processing:
  PureBand™ Crossover System
  Crossover Filter: Linkwitz-Riley 24dB per Octave
  Crossover Frequency Range: 50 HZ - 3kHz
  Crossover Mode: Crossover (CH1= LPF, CH2=HPF), LowPass (both channels LPF), HighPass (both channels HPF), Bridge (LPF or HPF).
  Peakx™ limiters: Channel independent clip limiter designed to provide maximum output while protecting your loudspeakers
• Input/Output:
  InputConnectors: XLR (one per channel), 1/4" (one per channel), and RCA (one per channel). 1/4" connectors can be used asloop-thrus to distribute signal to additional amplifiers.
  Output Connectors: Two 4-PoleSpeakon® Output Connectors accept 2-pole or 4-pole Speakon® connectors. The top Speakon connector is wired for both channels soit can be used for bridge mono wiring or for stereo wiring of two speakers to a single Speakon connector.
  One pair of back-panel binding posts per channel; accepts banana plugs or bare wire. (European models do not accept banana plugs.)
• Construction: 8.12" depth
• Dimensions: 3.5" H x 19" W x 7.7" D
• Weight:
  • Net: 8.6 lbs
  • Shipping: 13.6 lbs